The scooter has been received and installed, finally the long awaited moment, the scooter. The desire to stick the key into the hole, press the button and hear the hum of the engine is irresistible in the area ...
But it must be resisted. Although the above may seem ideal, it is not the case. Imagine a car that was parked for six months, can not begin on the first try. In this case, we're on a scooter, for 6 months or more, may have sat down to talk, in addition to travel aroundSea for 2 or 3 weeks, carburetor love salty fresh sea air.
Jump Starter
This article aims to guide the owners of scooters for the first time to start properly without blowing your scooter out of nowhere.
Dos and don'ts:
1. If the scooter is 50 cc or 150, do not look for his departure, the first impulse for only
2. Do not try at all costs, to help launch the scooter
3. Avoid the use of a charger. The engine will recharge the battery when it is launched. If a charger is used, it is certainly amotorcycle battery charger does not exceed 2 amps
4. If the scooter is equipped with an alarm, do not you try to start the alarm or the remote control to start the scooter
5. Buy the more expensive fuel and fill the tank
6. Do not use fuel additives or carburetor cleaner solution
7. Once the scooter is started, be ready for at least 15 minutes to charge the battery - let the engine is by far the best battery
Remember that a new batteryvery fragile. If all goes to the core, can result in permanent damage and damage other components such as fuse, voltage regulator and / or CDI. To protect the battery and other components, all 50cc and 150cc scooters must first be started with the kick-off then try the e-start a couple of times, as described below.
Since most 250 will not start on a kick scooter, 250cc scooter owners should follow the procedure of e-start.
StartProcedure:
1. Fill the tank with the best fuel available
2. Put the bike on center stand
3. Check the kill switch is on the rim, did not X
4. If the scooter came with remote control, click the UNLOCK button twice in a row
5. Turn the key to
6. Accelerate all the way and block the throttle open from 1 second, repeat 3 times
7. Flip Kick-Start, press gently with your foot halfway
8. Let the Kick Starterback up
9. Kick the kick starter make a strong 3 or 4 times in a row that the starter and go all the way back all the way every time
10. Then the acceleration of all types (paragraph 6) and kicked all the way to keep a couple of times (paragraph 9)
11. Do not speed while kicking
Try to get the electric start only after attempting to start the bike, as described above have to kick-start.
Electric starting procedure:
1. Follow steps 1 to 6 of the kick-off proceduretop
2. Keep the rear brake
3. Turn the gas pedal to pick up the game, not speed, just keep the slack
4. Press the start button for 3 seconds and
5. Accelerate all the way and let go to keep everyone loose in the gas
6. Press the start button for 3 seconds and
7. Let the electric starter to cool for 30 or 40 seconds and repeat the steps above again.
The overheating of the engine starting electric motor can also damage theblowing parts starter, backup and other electrical equipment.
If the bike is not started, do not try and process-start to go more than 2 times, but again the Kick Start procedure and repeat 2 or 3 times. It may take a few tries, most bike starts on 2 or 3 attempts.
If all else fails:
Some scooters have a hard time my start. This may be due to several factors. In 90% of the cases is the lack of activation in the absence of much or too little fuel for the alwaysCarburetor. The easiest way to control and treat them, the first carburetor manually:
1. Open the seat
2. Loosen the carburetor access panel screw (usually a single screw)
3. Remove the cover and locate the carburetor
4. The top of the carburetor looks like a metal dome with 2 screws holding it
5. Remove the 2 screws at the top of the carburetor
6. Place 3-4 tablespoons of fuel directly into the carburetor
7. Replace the top of the carburetorand secure with 2 screws
8. Follow the steps E-start only if it is not followed more than 3 times, otherwise kick-start
If the scooter does not start up, those with limited mechanical skills and those who are just dangerous to know enough to invited technical support department of the dealer scooter was made in the purchase or a consultation with a professional mechanic in contact .
How to start a scooter the first time
No comments:
Post a Comment